Upgrading from NT4.0 with SP6

G

Guest

I can's do anything anymore. I can remove this file or go to a prompt. Help
A problem has been detected and windows has ben shut down to prevcent damage
to your computer.

The problem seems to be caused by the following file: NeroCdnt.sys

An attempt was made to write to read-only memory\\

If this is the first time you’ve seen this Stop error screen,
restart your computer. If this screen appears again, follow
these steps:

Check to make sure any new hardware or software ois properly.
If this is a new installation, as your hardware or software manufacturer
for any windows updates you might need.

If problems continue, disable or remove any newly installed hardware or
software. Disable BIOS memory options such as caching or shadowing.
If you need to use Safe mode to remove or disable componente, restart
your computer, press F8 to select Advanced Start Options, and then select
Safe Mode.

Technical Information:

*** Stop: 0x000000BE (0x805A0E0C, 0X005A0121, 0XFE23A418, 0X0000000B


*** NeroCdNt.sys – Address FE231518 base at FE22F000, DateStamp 34321405
 
M

Mark L. Ferguson

Boot to Safe Mode (F8 on restart) and use the add/remove app in control panel to remove the Nero software
 
G

Guest

Safe mode takes me to the same area. I can't get past this message no matter
what I do.
 

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Top