suspend to RAM standby stage

[Edo]

How do I switch to "Suspend to RAM" standby stage?
This is what I asked not long ago

"Does the computer heat up on standby? Because when i put
the computer on standby the cooling fan doesnt turn off
and its too loud. Anyone have any suggestions?"

And the answer I got was this

"There are different stages of standby. If you
use "Suspend to RAM", the computer is essentially off.
There is only a small trickle current keeping the RAM
alive. Not much heat, if any, is generated."

Does anybody know how to turn on Suspend to RAM standby
mode?

 

[Guest]

When in stand-by mode the computer fans will always be running,
if you have a loud fan replace it,youre probably hearing bearing noise.
All these fans can have the bearings lubricated,remove the plastic sticker
(seal),remove the c-clip (carefully),then remove the plastic washers,clean
and lubricate.Remember use minimal lubricant.

 

[Guest]

-----Original Message-----
How do I switch to "Suspend to RAM" standby stage?
This is what I asked not long ago

"Does the computer heat up on standby? Because when i put
the computer on standby the cooling fan doesnt turn off
and its too loud. Anyone have any suggestions?"

And the answer I got was this

"There are different stages of standby. If you
use "Suspend to RAM", the computer is essentially off.
There is only a small trickle current keeping the RAM
alive. Not much heat, if any, is generated."

Does anybody know how to turn on Suspend to RAM standby
mode?
.
Reset your CMOS Bios setting by pressing F10 on startup