NTFS format

G

Guest

Hi,
I would like to format 1GB DOM with NTFS format.
I copied an image in XPe to above formatted DOM, and tried to deploy it.
However FBA didn't start and only cursor blinks on the left upper corner
after POST.
Did I take a wrong way of NTFS format?
 
C

crus

nami,
did you set the partition you formatted as active?
Where did you format DOM? Perhaps the boot sector is not correct, remove the
partition and try again in a XP, XPE or 2000 device.
Regards Raffaele
 

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Similar Threads

Disk On Module IDE problem 11
ntldr is missing if 256 DOM is formatted as FAT 32, but work fine 2
Adding NTFS to a CF Device 5
XPe cannot boot from CF in NTFS format 3
fba.exe Application error 3
Hard disk boot 1
No boot from NTFS CF Image 2
EWF RAM mode error1. 3

Top