Lexmark x75 problem

  • Thread starter Thread starter Janelle
  • Start date Start date
J

Janelle

When I try to print a document on my Lexmark X75 printer,
it prints fine, but in the window that shows the status,
it stops at 99% even though it is finished. To print a
document after that, I have to restart my computer and
then it will work. I don't know why it won't go to 100%
and then let me print documents after that, because
sometimes i need to print a few documents right after
each other. If anyone has any ideas on how I can fix
this, or has the same problem, please let me know!!
 
hi,,, i have the lexmark x 125 all in one printer. I am pulling my hair out...i can't install it,,,,it doesn't work at all,,,,and my computer doesn't recognize it at all,,,i don't know what to do next...got any ideas,,,,i'm listening,,,
thanks
glinda
 
Disconnect printer from PC.

Ensure that nothing remains from anything you did managed to get installed.

Follow Bruce Sanderson's instructions on how to completely clear up all
remaining Lexmark software.. pay particular attention to his section on
Lexmarks.

After the cleanup, reboot the PC... download a new set of software from
www.lexmark.com and install it. Do NOT connect the printer to the PC until
the software tells you to do so.

Cari
www.coribright.com
 
Sounds like corrupted drivers.

Disconnect printer from PC.

Uninstall and reinstall using...
http://members.shaw.ca/bsanders/CleanPrinterDrivers.htm

Follow Bruce Sanderson's instructions on how to completely clear up all
remaining Lexmark software.. pay particular attention to his section on
Lexmarks.

After the cleanup, reboot the PC... download a new set of software from
www.lexmark.com and install it. Do NOT connect the printer to the PC until
the software tells you to do so.

Cari
www.coribright.com
 
Back
Top