How To Fix Startup Files That Do Not Startup?

G

Guest

The files that are expected to run in the startup section of msconfig do not
always start up all the files. I have run registry cleaners, etc. yet the
problem persists. I must start up these orphaned files manually after a
system restart.

Does anyone have any suggestions on how this might be remedied? Thanks.

MH
 
K

Ken Blake, MVP

The files that are expected to run in the startup section of msconfig do not
always start up all the files. I have run registry cleaners, etc. yet the
problem persists. I must start up these orphaned files manually after a
system restart.

Does anyone have any suggestions on how this might be remedied? Thanks.



I can't help with your problem, but I urge you to avoid running
registry cleaners. They may possibly have exacerbated your problem.

I strongly recommend *against* the routine use of registry cleaners.
Routine cleaning of the registry isn't needed and is dangerous. Leave
the registry alone and don't use any registry cleaner. Despite what
many people think, and what vendors of registry cleaning software try
to convince you of, having unused registry entries doesn't really hurt
you.

The risk of a serious problem caused by a registry cleaner erroneously
removing an entry you need is far greater than any potential benefit
it may have.
 
P

Poprivet

mbhinz said:
The files that are expected to run in the startup section of msconfig
do not always start up all the files. I have run registry cleaners,
etc. yet the problem persists. I must start up these orphaned files
manually after a system restart.

Does anyone have any suggestions on how this might be remedied?
Thanks.

MH

GADS!!
 
R

Rock

The files that are expected to run in the startup section of msconfig do
not
always start up all the files. I have run registry cleaners, etc. yet the
problem persists. I must start up these orphaned files manually after a
system restart.

Does anyone have any suggestions on how this might be remedied? Thanks.

What, exactly, isn't starting consistently?

Without knowing more, one possible solution is to enter the services snap
in, from Start | Run | Services.msc | Ok. Then disable one or both of these
below listed two services. Disable one, test. If that doesn't do it,
enable that one and disable the other, test again. If no go, disable both
of them:

SSDP Discovery Service
UPnP Service

Most users don't need these services so there is normally no downside to
disabling them. For info on these services see this link:
http://www.blackviper.com/WinXP/service411.htm

On a final note, I concur with what Ken said. Do not use a registry
cleaner. There is a greater chance it will create a problem than fix one.
Unused (orphaned) entries in the registry, do not as a rule cause problems,
but removing the wrong item can.
 

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Top