DVI & Analog Setting

[eric_tan2020]

Good Day Everyone,

I just bought a View Sonic 20" LCD Monitor.

Anyone can teach me how set it so that I can use the DVI output?

I'm using PX7300 graphic card.

I try to use the DVI cable plug it into LCD and graphic card, when I switch on the PC, the screen show no analog signal.

Anyone can teach me?

Thank you

 

[floppybootstomp]

It should be a case of just plugging the monitor in from the Video card using a DVI cable, assuming both the card and the monitor have DVI output and input.

I actually had the same problem a while back and odd though it may seem, a bigger power supply solved the problem, I upgraded from 480W to 700W.

I first proved it was not enough current available by disconnecting the power from two optical drives and one hard drive, and then the DVI connection worked.

And that's about the only thing, barring a fault in either component or the connecting cable, that I can think of.

 

[Alf]

Hate to ask this, but.... is it plugged in and switched on?