Winsock error (XP sp2).

[Hubert Wi¶niewski]

Hi,

One of my users turn off computer during closing of system and it caused
a problem with TCP/IP protocol. The computer can't obtain IP address
from DHCP, can't use static IP address. I can't use command: ipconfig
(there is problem with this command, please contact with your
administrator), ping 127.0.0.1 (there is a problem with IP, error code
no 2). I tried to reset internet protocol:
(http://support.microsoft.com/kb/299357/en-us) but without results.
When I run command: 'netsh int ip reset' in logfile I see that there is
a problem in the same section:

[deleted
SYSTEM\CurrentControlSet\Services\Tcpip\Parameters\UseDomainNameDevolution
reset Linkage\UpperBind for
PCI\VEN_10EC&DEV_8139&SUBSYS_813910EC&REV_10\4&2FF3801D&0&0850. bad
value was:
REG_MULTI_SZ =
PSched

reset Linkage\UpperBind for ROOT\MS_NDISWANIP\0000. bad value was:
REG_MULTI_SZ =
PSched

<completed>]

and later on I run the same command again and there is a bad value in
the same place:

[deleted
SYSTEM\CurrentControlSet\Services\Tcpip\Parameters\UseDomainNameDevolution
reset Linkage\UpperBind for
PCI\VEN_10EC&DEV_8139&SUBSYS_813910EC&REV_10\4&2FF3801D&0&0850. bad
value was:
REG_MULTI_SZ =
PSched

reset Linkage\UpperBind for ROOT\MS_NDISWANIP\0000. bad value was:
REG_MULTI_SZ =
PSched

<completed>]

I think that this command can't solve 'my' problem. Is there any way to
repair TCP/IP ?

BR
Hubert

 

[FrankFL]

Hi,

One of my users turn off computer during closing of system and it caused
a problem with TCP/IP protocol. The computer can't obtain IP address
from DHCP, can't use static IP address. I can't use command: ipconfig
(there is problem with this command, please contact with your
administrator), ping 127.0.0.1 (there is a problem with IP, error code
no 2). I tried to reset internet protocol:
(http://support.microsoft.com/kb/299357/en-us) but without results.
When I run command: 'netsh int ip reset' in logfile I see that there is
a problem in the same section:

[deleted
Hubert

It is a given that files were corrupted by the bad shut down.
I would try:
sfc /purgecache then sfc /scannow
The up to date XP install CD will be needed.

 

[Hubert Wisniewski]

Hi,

One of my users turn off computer during closing of system and it caused
a problem with TCP/IP protocol. The computer can't obtain IP address
from DHCP, can't use static IP address. I can't use command: ipconfig
(there is problem with this command, please contact with your
administrator), ping 127.0.0.1 (there is a problem with IP, error code
no 2). I tried to reset internet protocol:
(http://support.microsoft.com/kb/299357/en-us) but without results.
When I run command: 'netsh int ip reset' in logfile I see that there is
a problem in the same section:

[deleted
Hubert

It is a given that files were corrupted by the bad shut down.
I would try:
sfc /purgecache then sfc /scannow
The up to date XP install CD will be needed.

Ok, thank you

BR
Hubert