Window 2000

  • Thread starter Thread starter Hoan Nguyen
  • Start date Start date
H

Hoan Nguyen

Hi,
I was upgrading an older machine (it's only a PII)
from Win98SE to Win2K. I started with a clean hard drive
and installed Win2K just fine (formated - NTFS).
However, after the installation process the system
restarted and during the bootup (when you see the Win2K
logo and the status bar at the bottom) it just hangs, my
monitor turns off (like it getting no signal) and the
only thing that I can do (after waiting for about 20
minutes) is to reboot and the same thing happens. I
thought at first it was because I formated for NTFS, so I
tried FAT32 and got the same result. Any suggestions?

Thanks
 
Read CDROM:\support\hcl.txt.
It looks like Windows uses improper (W98) video driver. Boot in Safe or VGA
mode, unistall driver and reboot.
 
You must log in or register to reply here.

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Similar Threads

Win2k installation hangs .... 3
Windows looping install 3
Need help - dual booting 4
NTLDR missing after new harddisk 1
win2k clean install from win98 in toshiba laptop a20-31q 2
need Win2k system restore help 2
Win2k setup, problems while installing 1
HDMI is a terrible format and I wish it never existed 2

Back
Top