MM2 first renders the project to a temporary DV-AVI file and then copies the
file to the camcorder. The rendering usually takes longer than real time,
and the transfer to tape has to be in real time.
If you have problems, it might pay to save the DV-AVI file to your hard
drive first, and then use the WinDV utility (link on the Camcorders...
Introduction page) to copy it to the camcorder.
--
PapaJohn
www.papajohn.org
JCskidd said:
I've started the transfer back to tape and appears I followed all the
directions in MM2, but the counter on my camera's not moving. I made sure
it was in play/vcr mode not camera mode. MM2 says recording back to camera.
Does it save all the file to my hard drive first and then put it on tape or
what?