still got error when add a user to group

[engine]

Thank you for your help. But I check my system with the
three documents, and found the configuration is correct.
But why still got the same error when try to add the user
to a group?

-----Original Message-----
There are a few reasons that this can happen. See the three articles below

284914 Error Message: Object Picker Cannot Open Because No Locations from
Which
http://support.microsoft.com/?id=284914
263231 Error Message: Object Picker Cannot Open Because no Locations from
Which
http://support.microsoft.com/?id=263231
258960 More Than 15 IP Addresses Assigned to Server Causes Active
http://support.microsoft.com/?id=258960

--
Tim Hines, MCSE, MCSA
Windows 2000 Directory Services

=====================================================
When responding to posts, please "Reply to Group" via
your newsreader so that others may learn and benefit
from your issue.
=====================================================
This posting is provided "AS IS" with no warranties, and confers no rights.





.

..

 

[Tim Hines [MSFT]]

It can also happen if some app replaced some of the system dlls. Try
running sfc \scannow on your system. That will cause the system to checked
for mismatched dlls.


--
Tim Hines, MCSE, MCSA
Windows 2000 Directory Services

=====================================================
When responding to posts, please "Reply to Group" via
your newsreader so that others may learn and benefit
from your issue.
=====================================================
This posting is provided "AS IS" with no warranties, and confers no rights.