modem usb configur by netsh

[guidi fabio]

hi
f i want configure moden in cmd prompt, it is possibile?
is possibile use netsh? in this case what are the
component for this context in netsh?
Best regards

 

[Heidi Linda eMVP]

Guido, your problem is your modem driver. Either you've
installed it, in which case it's probably missing a
dependency somewhere, or you've componentised it, and
there's a problem with the component. Using netsh is not
going to sort out the speed problem with your modem.

 

[guidi fabio]

excusme but the error modem is 678 There is no answer, in
same case in other the modem connect to remote computer
but the speed is 300 bps (with same hardaware windows2000
call at 33.6kbps), for the driver of the component i
import *.inf in component designer e create the copmonet
U.S robotics 56k faxmodem usb the driver was for XP if i
query modem in diagnostic the modem answer me and i thing
that the driver of modem is ok
Can you help me?
best regards

 

[Slobodan Brcin]

In that case, are you sure that you have driver for modem. Last time I used
modems they were using only inf files to define various AT settings and
response strings. Most of them (not software modems) work without anything
else.

You need to set some AT strings than will initialize it by default, when you
dial, they are modem specific, and you can read them from working XP, or win
2000.

Best regards,
Slobodan

 

[Heidi Linda eMVP]

Can we keep this issue in this one thread and not start a
new one again? Thanks.
The error you reported before was 674, which was to do
with not being able to read the speed from the .inf file,
which sounds very likely to be responsible for your
problem.
Whether this was the error or not, you have two
possibilities - your driver is broken, or your driver has
dependencies you don't know about.
I would suggest you install the driver normally on the Xpe
image. If this corrects the problem, then you know your
driver component is at fault, and I suggest you use inctrl
5 (available from xpefiles.com) to track the installation
on an XPPro system and create a new component from this
information.
If you cannot install the driver, please report what
problems you have *in this thread* and we'll try to get
you sorted out.
If installing the driver works, but you still have the
same problems, then you know you are missing a dependency
somewhere.

 

[A. Trompetto]

Ciao Fabio,

If your modem is a U.S robotics faxmodem 1801 or TI then the driver is also supported by MS, and you can find it in TD. Maybe you
can try with that driver.
Also, try to check your country settings in the Modem Control Panel.

HTH
AT

 

[guidi fabio]

i install the modem after fba of xpe the message of
install is success, in phone and modem the modem is
configurated on com1, i create the connection with wizard
the connection is not aviable and the led of the modem is
off
when i make the immage with component of modem the modem
is configurate on com3 and the led on the modem is on the
connection create with wizard new connection is aviable
and the modem dial in same case the connection is
interrupt error code 678 There is no answer. in ather the
connection is ok and speed 300bps
the modem in question is u.s. robotics 56k faxmodem usb
best regards