Lexmark X63 Printer

[Tracy]

I have installed the Lexmark X63 printer and when I print
nothing appears on the page. Any help will be
appreciated, you can email me or reply to this
post.....thank you!!!

 

[Tracy]

Also, I am using a USB Port.

 

[Victor D.]

These problems are all over this newsgroup, I copied this from a pervious
one on an earlier date. Hope this helps. Norious for Lexmarks. Read below
carefully |
V

Original quote by Cari:
It's a Lexmark. Disconnect the printer from the PC.

Use Bruce Sanderson's instructions to COMPLETELY uininstall ALL printer
drivers... and pay particular attention to his special section on Lexmark
printers.

http://members.shaw.ca/bsanders/CleanPrinterDrivers.htm

After the cleanup, reboot the PC. Download a new set of Lexmark printers
from the Lexmark website.

Install the software and DO NOT reconnect the printer until the software
tells you to do so.

Cari

 

[Tracy]

Thank you for the post.

I have the printer printing but it is cutting some words
off when it prints. I cleaned the printer but that
didn't help.

any advice?

 

[Victor D.]

Question, what do you mean you cleaned the printer???? Did you uninstall
all drivers and reinstall EP compatible driver back with printer
disconnected and then reconnect printer? Details are very important.

Follow these intructions:
http://www.coribright.com/Windows/Article One.htm

 

[Victor D.]

**Question, what do you mean you cleaned the printer???? Did you uninstall
all drivers and reinstall XP compatible driver back with printer
disconnected and then reconnect printer? Details are very important.

Follow these intructions:
http://www.coribright.com/Windows/Article One.htm

 

[Cari \(MS-MVP\)]

It's a Lexmark....

to uninstall it, you must follow the instructions on Bruce Sanderson's
webpage as Lexmarks can be very difficult (putting it politely) to
uninstall. Disconnect the printer from the PC.....

http://members.shaw.ca/bsanders/CleanPrinterDrivers.htm

After the complete cleanup, reboot the PC. Download a new set of printer
drivers from the Lexmark website at www.lexmark.com and install the
software. Do NOT reconnect the printer until the software tells you to do
so.

Cari
www.coribright.com

 

[Mechanix]

-----Original Message-----
I have installed the Lexmark X63 printer and when I print
nothing appears on the page. Any help will be
appreciated, you can email me or reply to this
post.....thank you!!!
.
If i see one more person post 2 uninstall and reinstall

with the downloaded driver im going to cry. First of the
downloaded driver is the same driver verison that would
be on your DISC!...Thats right no changes, so its a waste
of your time.....
First, after you click print does it try to write on your
page or does it just feed a sheet....?

You may want to change your print pross...change over 2
winprint...WINPRINT\RAW
Or if you wish 2 use the lexmark pross change from lemf
to raw data type

Start,control pan, printers and faxes,right click your
printer, select prop, then click on advanced, the print
processor

This sometimes works with blank printing and older
lexmarks.