firewire IEEE 1394 keeps restarting xp pro

  • Thread starter Thread starter eggheed
  • Start date Start date
E

eggheed

I have discovered that when I instal the IEEE 1394 PCI
card received with Dazzle DV Editor that the XP Pro
operating system keeps restarting.When I remove it the
problem is rectified. Has anyone any suggestions.

Thanks

PS Thanks to Will for helping me get this far!
 
I have discovered that when I instal the IEEE 1394 PCI
card received with Dazzle DV Editor that the XP Pro
operating system keeps restarting.When I remove it the
problem is rectified. Has anyone any suggestions.

Thanks

PS Thanks to Will for helping me get this far!

Try moving the card to another PCI slot if one is available. Also
check in your system BIOS (consult your MB manual to learn how to
enter BIOS setup) and make sure that IRQs are assigned automatically.

As a general rule, XP should support most Firewire cards if they are
in fact IEEE 1394 standard. There is a chance the card is not
compatible with XP or there is an IRQ conflict somewhere with it.
 
I have discovered that when I instal the IEEE 1394 PCI
card received with Dazzle DV Editor that the XP Pro
operating system keeps restarting.When I remove it the
problem is rectified. Has anyone any suggestions.

Thanks

PS Thanks to Will for helping me get this far!

egghead:

I recently installed this card:

OrangeLink FireWire 800/1394b (1394a + b) PCI card
http://www.orangemicro.com/fw800pci.html

Using the 1394a port to specifically to run this:
1x250GB Maxtor One Touch USB2/fw external Ultra ATA-133 7200RPM HDD

I don't currently have a 1394b device but installed the 1394b
drivers anyway in case I get a b device.

The card and drive run as advertised. No installation nor
performance problems.

One of the reasons I chose this card is that it has a +12V on-card
connector for drawing power directly from the PSU. One doesn't have to
use it but the less power you pull from your PCI slots the better. I
also have 2 ATA-133 HDDs on a controller card and a sound card using
the PCI slots.

Download the manuals from the site if you like.

WinXP HE SP1 full/clean
Asus P4T533-C s478/i850e
P4 2.8GHz/533MHz FSB retail
1GB (4x256MB) OCZ PC1066 RIMMs
etc

Happy trails,


Fleabus ..............

Please remove the X from my address to e-mail me.
 

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Back
Top