rj1975 said:
Trying to re-install WinXP Pro
Getting this error:
The following value in the .SIF file used by Setup is
corrupted or missing:
Value 0 on the line in section [SourceDisksFiles] with
key "SP1.cab."
Setup can not comtiue
Without more specific information about your computer, the problem that
caused you to reinstall, whether you are doing a repair or clean
install, etc., I can only give you a generic answer:
There are two ways of installing XP - a clean install where the hard
drive is formatted first and an upgrade install where the new operating
system is installed "on top" of the old operating system. If you are
doing the latter, try a clean install instead. Formatting the drive
will wipe all current data, so you would expect to reinstall programs
from cd and restore data from backups. Be sure all peripherals
(printers, scanners, cameras) are disconnected and any BIOS-level
antivirus is disabled. If you are already doing a clean install and the
installation is failing, you probably have bad hardware. Start with a
RAM test - I like Memtest86 from
www.memtest86.com - and let the test
run for an extended time, like overnight (unless you get errors
immediately). If the RAM is good, then run a hard drive diagnostic
utility, which you can get from the drive mftr.'s website.
Malke
