Won't boot with USB printer connected.

  • Thread starter Thread starter paul
  • Start date Start date
P

paul

We have an XP Home Edition with an HP Multifunction unit
connected via USB.

The computer will not boot up with the multifunction unit
connected. If the unit is disconnected from the USB port,
the computer boots.Then unit works fine if it's connected
after booting. The computer will shut down normally, but
will not boot up again with the unit connected.

Any ideas?

Thank you. p[aul
 
My brother had this problem. Turned out to be a cmos
setting. Check your cmos for usb settings and try
switching from on to off.
 
You must log in or register to reply here.

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Similar Threads

Sluggish Alexa Response 6
USB port not functioning properly? 4
usb printer, boot hang problem 13
QNAP TS-653B 2
USB trouble 12
Computer starts up when I plug in printer's USB cable. 1
USB help 1
System does not boot when connecting hard drive to SATA card vs on-boardSATA controller 5

Back
Top