Windows Firewall function

[Guest]

Hello from Japan.

I would like to disable Windows Firewall.
So I tried following two methods;
1.Not apply the component; Windows Firewall/Internet Connection Sharing
(ICS).
2.Apply the component; Windows Firewall/Internet Connection Sharing
(ICS), and then select "OFF" the function; Windows Firewall Settings.

However both of methods did not disable the service; Windows
Firewall/Internet
Connection Sharing (ICS).

Do you know any methods which disable the Windows Firewall?

I look for your reply.

 

[Guest]

hi Nami,

U just set the value to zero for the registry entry to disable the fire wall.

HKLM,"System\CurrentControlSet\Services\SharedAccess\Parameters\

FirewallPolicy\StandardProfile","EnableFirewall"

Regards,

KSMH

 

[KM]

nami,

Are you saying that if you remove the "Windows Firewall/Internet Connection Sharing (ICS)" component from your image, the Windows
Firewall/Internet Connection Sharing (ICS) service is still running? This would be surprising since the Windows Firewall/Internet
Connection Sharing (ICS) service is a Service Data resource of the "Windows Firewall/Internet Connection Sharing (ICS)" component.

Are you sure that component doesn't get pull in by auto-dependency resolver in TD?

Read here on a few ways how you can disable the firewall in TD or at run time:
http://msdn2.microsoft.com/en-us/embedded/aa731196.aspx

 

[Guest]

Dear KM&KSMH:

Thank you for your reply.
I unchecked "Windows Firewall/Internet Connection Sharing (ICS)"in "Core
Networking"component,
so Firewall component does not get pull in by auto-dependency resolver in TD.
If I check the Service after FBA, I see Firewall in there!
Eventhogh, "Windows Firewall/Internet Connection Sharing (ICS)" does not
exit in the component!!

Do you think slx file is damaged?

 

[KM]

nami,

Can you share your SLX with us?

Or, perhaps, you can start a new project and check if you remove the component and turn off the auto-dependency resolver the
Firewall service is still there in post FBA image.

 

[Guest]

Thank you, KM!
I tried your advice.
I started and created a new project, and run FBA again.
But still the Windows Firewall was there.
However Firewall service its self had not been running. ( Status:Null,
Startup Type:Automatic)
It looks like that if I install "Core Networking", Windows Firewall
component is automatically installed
also.
It will be a bothersome task, but I deleat Firewall service manually after
FBA.

Thank you for your advice.

 

[KM]

nami,

I wonder if any of the following components are in your image:
Dial-Up Networking Common Libraries [Version 5.1.2600.3333, R3333], [Visibility=200]
Dial-up Server for Windows [Version 5.1.2600.2180, R2890], [Visibility=1000]
Networking Application Compatibility [Version 5.1.2600.2180, R2890], [Visibility=1000]