usb device software wants com port

  • Thread starter Thread starter reap
  • Start date Start date
R

reap

I have a usb device. I am trying to get software to work for it, but the
software is asking which com# port device is on. How do I get this to work?
 
Start by reading though the installation instructions for the usb device
once. Then follow them step by step as you install it.
 
It's a coin acceptor with a USB input. It works with the software it came
with because there is a choice between USB and COM# ports. I am trying to
get it to work for a coin accepting jukebox and all the software I can find
only has COM# ports and no USB port selection. I need to get the computer to
recognize the device as a COM# input device to work with the software.
Thanks for the help. Keep trying.
 
The correct driver that is supplied with the device will need to be
installed for the system to see it on the USB and allow COM nuber to be set.
 

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Similar Threads

How do I clean out unwanted virtual COM ports? 7
Remove phantom com ports from the registery ... how ? 5
comport is inactive 1
USB TO RS232 ..more than one in pc ? how to know which is which ? 3
Ports (COM&LPT) heading disappeared from device manager. 2
USB complains about not being high speed. 11
usb GPS device autodetects as mouse 5
Removing Devices from USB Ports 4

Back
Top