turn on restore

  • Thread starter Thread starter bosco
  • Start date Start date
B

bosco

I have 2 hard drives each with a partition...C:D:G:H: and
the C: does not show up as being monitored for system
restore. It says that G: is the system drive but it
should be C: How do I get C: to show up and turn on the
system restore for it?
 
Hi,

1) You can't change the system partition drive letter once installed. If you
have tried to, you should undo whatever damage you have already done.

2) Control Panel/system/System Restore tab, click on settings to selectively
enable monitoring on various drives.

--
Best of Luck,

Rick Rogers aka "Nutcase" MS-MVP - Win9x

Associate Expert - WinXP - Expert Zone
 
The C: doesn't show up at all in the Control
Panel/system/System Restore tab It shows G: as the system
drive (which it's not)and no C: drive at all. Thanks
 
You must log in or register to reply here.

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Similar Threads

System restore problem 7
System restore problems 18
System Restore all off, still creating restore points on 2nd parti 5
Question about System Partition and Active Partition 3
Image C: 16
Restoring disk image 6
Windows XP restore fails 7
Windows 8 System Restore turned off and 'Turn on system protection' greyed out 1

Back
Top