system down for STOP:0X00000077

[automation]

Hi, our system with Windows XP Embedded some times down
for this error:

A PROBLEM HAS BEEN DETECTED AND WINDOWS HAS BEEN SHUT DOWN
TO PREVENT DAMAGE TO YOUR COMPUTER.

KERNEL_STACK_INPAGE_ERROR

IF THIS IS THE FIRST TIME YOU' VE SEEN THIS STOP ERROR
SCREEN, RESTART YOUR COMPUTER. IF THIS SCREEN APPEARS
AGAIN, FOLLOW THESE STEPS:

CHECK TO MAKE SURE ANY NEW HARDWARE OR SOFTWARE IS
PROPERLY INSTALLED. IF THIS IS NEW INSTALLATION, ASK YOUR
HARDWARE OR SOFTWARE MANUFACTURER FOR ANY WINDOWS UPDATES
YOU MIGHT NEED.

IF PROBLEM CONTINUE, DISABLE OR REMOVE ANY NEWLY INSTALLED
HARDWARE OR SOFTWARE. DISABLE BIOS MEMORY OPTIONS SUCH AS
CACHING OR SHADOWING. IF YOU NEED TO USE SAFE MODE TO
REMOVE OR DISABLE COMPONENTS, RESTART YOUR COMPUTER, PRESS
F8 TO SELECTED ADVANCED STARTUP OPTIONS, AND THEN SELECT
SAFE MODE.

TECHNICAL INFORMATION:

STOP:0X00000077
(0XC000000E,0XC000000E,0X00000000,0X002AB000)

We have read the Microsoft documentation about the error
but for state I/O code= 0xC000000E nothing is indicated.

What are the probably causes of the our down?

Thanks

Best Regards

Ufficio Automazione
Grasseni Piergiorgio.

 

[KM]

Did you happen to add paging file support to your image?
If so, you may plug out the target storage and clean up paging file from it
using your dev machine. Please also run Disk Check to mark any bad blocks on
your target hard drive.

Here are the article related to the BSOD you see:
http://msdn.microsoft.com/library/default.asp?url=/library/en-us/w2kmsgs/122
4.asp
http://support.microsoft.com/default.aspx?scid=kb;en-us;130801

KM


a> Hi, our system with Windows XP Embedded some times down for this
a> error:

a> A PROBLEM HAS BEEN DETECTED AND WINDOWS HAS BEEN SHUT DOWN
a> TO PREVENT DAMAGE TO YOUR COMPUTER.

a> KERNEL_STACK_INPAGE_ERROR

a> IF THIS IS THE FIRST TIME YOU' VE SEEN THIS STOP ERROR
a> SCREEN, RESTART YOUR COMPUTER. IF THIS SCREEN APPEARS
a> AGAIN, FOLLOW THESE STEPS:

a> CHECK TO MAKE SURE ANY NEW HARDWARE OR SOFTWARE IS
a> PROPERLY INSTALLED. IF THIS IS NEW INSTALLATION, ASK YOUR
a> HARDWARE OR SOFTWARE MANUFACTURER FOR ANY WINDOWS UPDATES
a> YOU MIGHT NEED.

a> IF PROBLEM CONTINUE, DISABLE OR REMOVE ANY NEWLY INSTALLED
a> HARDWARE OR SOFTWARE. DISABLE BIOS MEMORY OPTIONS SUCH AS
a> CACHING OR SHADOWING. IF YOU NEED TO USE SAFE MODE TO
a> REMOVE OR DISABLE COMPONENTS, RESTART YOUR COMPUTER, PRESS
a> F8 TO SELECTED ADVANCED STARTUP OPTIONS, AND THEN SELECT
a> SAFE MODE.

a> TECHNICAL INFORMATION:

a> STOP:0X00000077 (0XC000000E,0XC000000E,0X00000000,0X002AB000)

a> We have read the Microsoft documentation about the error but for
a> state I/O code= 0xC000000E nothing is indicated.

a> What are the probably causes of the our down?

a> Thanks

a> Best Regards

a> Ufficio Automazione
a> Grasseni Piergiorgio.