E
Edna
Services – Manual Settings
WXP Pro SP3, 3.60 GHz, 2 GB RAM Single User Desktop DSL with Wireless
Connection to laptop. 2 HDs and Toshiba 250 External Drive
I Have the Following Startup Type Settings on “Manual†but …
I’ve found their Status Changes Immediately on Reboot/Shutdown to Status:
Started.
1. Application Layer Gateway
2. COM + Event System
3. HTTP SSL
4. Network Connections
5. Network Location Awareness
6. Remote Access Connection Mgr
7. SSDP Discovery Service
8. Telephony
9. Terminal Services
My Question is: As these particular Manual settings change to Started,
Should I change these “Manual†Settings to Automatic?
One I just noticed on “Disabled†that I now question what must have been my
decision:
10. Security Centre … I have it Disabled - it "Monitors System Security
Settings and Configuration".
Hmmm would this have been converted to “Disabled†because I HAD the WXP
Firewall Disabled as I was using Norton Internet Security 2008 as my
Firewall??
As of a few hours ago, I now have the free version 8.0 of AVG which doesn’t
appear to have a Firewall.
I just reactivate the WXP Pro SP3 Firewall and Shutdown but … this setting
is still on Disabled. I’m now presuming it’s ME that has to change this to
Automatic???
These setting are so confusing to a Novice. Well, just a stupid one I
guess.
Thx for any suggestions.
WXP Pro SP3, 3.60 GHz, 2 GB RAM Single User Desktop DSL with Wireless
Connection to laptop. 2 HDs and Toshiba 250 External Drive
I Have the Following Startup Type Settings on “Manual†but …
I’ve found their Status Changes Immediately on Reboot/Shutdown to Status:
Started.
1. Application Layer Gateway
2. COM + Event System
3. HTTP SSL
4. Network Connections
5. Network Location Awareness
6. Remote Access Connection Mgr
7. SSDP Discovery Service
8. Telephony
9. Terminal Services
My Question is: As these particular Manual settings change to Started,
Should I change these “Manual†Settings to Automatic?
One I just noticed on “Disabled†that I now question what must have been my
decision:
10. Security Centre … I have it Disabled - it "Monitors System Security
Settings and Configuration".
Hmmm would this have been converted to “Disabled†because I HAD the WXP
Firewall Disabled as I was using Norton Internet Security 2008 as my
Firewall??
As of a few hours ago, I now have the free version 8.0 of AVG which doesn’t
appear to have a Firewall.
I just reactivate the WXP Pro SP3 Firewall and Shutdown but … this setting
is still on Disabled. I’m now presuming it’s ME that has to change this to
Automatic???
These setting are so confusing to a Novice. Well, just a stupid one I
guess.
Thx for any suggestions.