Problems with Touch screen and mouse

[AS]

Hi,

I earlier added the touch screen driver component from the xpefiles.com
website and have included that in my image. It uses the USB port for
communication. The problem is that during FBA, I can see and use my mouse
(which uses the PS2 port) but once this is completed, and XPe comes up, I
cannot seem to use my mouse in any way... I have installed the touch screen
driver on the win2k also and am able to use both the touch screen and mouse
at the same time.. Could there be any conflicts in here.. I'm using the
dynapro SC4 touch screen controller..

Thanks,
Regards,

 

[KM]

AS,

Did you use Dynaprosc3 component from www.xpefiles.com?

Do you see any SC4 or UPDD related errors in your FBALog.txt file?
AFAIK, the Dynaprosc3 component inclides the touch screen registry settings
that default to PS2 mouse. You may need to change that.

KM

 

[AS]

Yes I used the dynapro component... Problem is, after FBA, I have to
install the application (Run the .exe file) again and after installation, I
have to calibrate it. Every time I boot up, I again lose the mouse settings
and have to install the application again and calibrate it again...
Is there something to save the settings to disk/CF.. and I'm not using EWF..

Any help would be appreciated..
Thanks,
Regards,
AS

AS,

Did you use Dynaprosc3 component from www.xpefiles.com?

Do you see any SC4 or UPDD related errors in your FBALog.txt file?
AFAIK, the Dynaprosc3 component inclides the touch screen registry settings
that default to PS2 mouse. You may need to change that.

KM