Problems getting to some websites

[Guest]

We have a home network comprising 2 desk tops and one the laptop. One of the
desktop and the laptop are Windows XP and the second desktop is using Windows
98 SE.

One desktop is connected to a D-Link DI-614+ router, while the others are
using wireless connections. The router is connected to a cable modem.

On all of the computers we are able to access only about 40 percent of the
websites. The remaining 60 percent of the time we get the message "This page
is not available". However we connected the telephone line to the laptop and
used our dialup service and it worked perfectly. This problems started
recently.

I have followed all of the reccomendations of our ISP and cable provider but
these do not correct the problem.

Any suggestions or ideas?

Thanks

 

[Robert L [MS-MVP]]

this may help. quoted fromhttp://www.ChicagoTech.net
Can't access some web sitesSymptoms: 1) If you're using MS ICS or Windows
server as router to access the Internet, your clients may not be able to
access certain web sites. However, the ICS host or the server doesn't have
this problem.
2) After installed a new router or cable modem replacing dial-up to access
the Internet, you can't access some web sites.
3) You also find that most web sites you can't access are block to ping or
they are security sites using HTTPS.

Causes: 1) The problem occurs because many web servers block ICMP messages
and the packets are dropped. As a result, the requested web site doesn't
load.
2) This problem is caused also by an incompatible MTU networking setting.
You may try to install the latest SP. If you use MS ICS, you may want to
configure all your Client computers to use the new, lower MTU as the default
for all Internet communication. To modify the MTU size, locate the following
registry key: HKEY_LOCAL_MACHINE\ SYSTEM\ CurrentControlSet\ Services\
Tcpip\ Parameters\ Interfaces. If you use a router like Cisco DSL Router,
you may want to adjusting the PPPoE MTU Size. For example, to adjusting the
PPPoE MTU Size on the Cisco DSL Router, do

interface ethernet0
no shut
ip address <ip address> <subnet mask>
ip adjust-mss 1452


--
For more and other information, go to http://www.ChicagoTech.net

Don't send e-mail or reply to me except you need consulting services.
Posting on MS newsgroup will benefit all readers and you may get more help.

Bob Lin, MS-MVP, MCSE & CNE
Networking, Internet, Routing, VPN, Anti-Virus, Tips & Troubleshooting on
http://www.ChicagoTech.net
Networking Solutions, http://www.chicagotech.net/networksolutions.htm
VPN Solutions, http://www.chicagotech.net/vpnsolutions.htm
VPN Process and Error Analysis, http://www.chicagotech.net/VPN process.htm
VPN Troubleshooting, http://www.chicagotech.net/vpn.htm
This posting is provided "AS IS" with no warranties.