D
Dan
Hi guys,
Ok, I'm deploying an image to my target platform. Here's what happens:
1 - Deploy image to target platform. Reboot to run image w. PNP to
detect new hardware (single image deployed to multiple platforms
scenario).
2 - PNP occurs after reboot. Attempt to enable RAM EWF. Fails.
The ewfmgr fails with the "failed getting protected volume with error
1" error. If I reboot again and try to run ewfmgr, it works with no
problem.
My suspicion is that ewfmgr fails because in that boot cycle, PNP has
only just found the HDD and can't use it until the next reboot.
Rebooting allows the PNP changes to take effect and ewfmgr then works.
Does this make sense? Are there any workarounds, or will I need to
include another reboot in my deployment process?
Cheers,
Dan
Ok, I'm deploying an image to my target platform. Here's what happens:
1 - Deploy image to target platform. Reboot to run image w. PNP to
detect new hardware (single image deployed to multiple platforms
scenario).
2 - PNP occurs after reboot. Attempt to enable RAM EWF. Fails.
The ewfmgr fails with the "failed getting protected volume with error
1" error. If I reboot again and try to run ewfmgr, it works with no
problem.
My suspicion is that ewfmgr fails because in that boot cycle, PNP has
only just found the HDD and can't use it until the next reboot.
Rebooting allows the PNP changes to take effect and ewfmgr then works.
Does this make sense? Are there any workarounds, or will I need to
include another reboot in my deployment process?
Cheers,
Dan