No code executing in 2007

M

Mr B

I have a 2002 Access Db that works fine in 2002. When I open it in 2007 and
save it as a 2007 Db, no code behind any controls executes. I have tried
compiling and get no errors. I have also place a stop in my code and it just
does not run the code. If I use the properties window and go to the event
that is present, I am taken to the correct proceedure in the forms module. I
have even tried opening the original 2002 db in 2007 and again no code behind
any controls runs, including buttons.

What am I missing?

Any help is appreciated.

Mr B
 
M

Mr B

Thanks, Pete for the suggestion and link. I should have thought of that. I
suspose that I was just brain dead.

Thanks again.

Mr B
 
P

Pete D.

It is different, and in the right configuation it won't even tell you that
it is blocking all code. Takes a little getting used to. Pete
 

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Top