S
Spareone3
Model Name : GA-8I955X-Royal
--------------------------
M/B Rev : 1.1
BIOS Ver : f8
Serial No. : SN0543000024
-------------------------------------------------------------------------------
VGA Brand : GIGABYTE Model : 7800GT
CPU Brand : Intel Model : 830 Speed : 3GHz
Operation System : N/A SP :
Memory Brand : Corsair Type : DDRII
Memory Size : 2 x 512 Speed : 667
Power Supply : Aspire ATX-AS500W-BK
System fails to fully boot or enter BIOS setup, (Get 1 beep which is normal
I think). Will fully complete on screen Memory check OK finds 1Gb running in
Dual mode, IDE scan finds drives, then crashes/hangs and I lose VGA sync and
cannot even reset motherboard by case reset button! (Reset works OK if I
reset within first 2 seconds prior to hang) GigaByte DPS blue LEDs
illuminate one at a time and then all go out at point of hang. I have
cleared CMOS and removed motherboard from chassis disconnecting all but VGA
card. This is a new system build and therefore has never booted. No O/S is
loaded on the machine. I have a 24 pin connector fitted to m/b, however I
only have a 2x2 12V supply to the CPU. All literature suggests that only on
a 840 and 845 CPU requires 2x4 12V..Is this correct... I have worked with
Gigabytes boards week in and week out and this seems an uncommon failure,
however it is the first Dual core system and so this hardware configuration
is unproven!
Has anyone run an 830D on this or any other board using just the 2x2 12v P4
supply?
Any help would be appreciated!
--------------------------
M/B Rev : 1.1
BIOS Ver : f8
Serial No. : SN0543000024
-------------------------------------------------------------------------------
VGA Brand : GIGABYTE Model : 7800GT
CPU Brand : Intel Model : 830 Speed : 3GHz
Operation System : N/A SP :
Memory Brand : Corsair Type : DDRII
Memory Size : 2 x 512 Speed : 667
Power Supply : Aspire ATX-AS500W-BK
System fails to fully boot or enter BIOS setup, (Get 1 beep which is normal
I think). Will fully complete on screen Memory check OK finds 1Gb running in
Dual mode, IDE scan finds drives, then crashes/hangs and I lose VGA sync and
cannot even reset motherboard by case reset button! (Reset works OK if I
reset within first 2 seconds prior to hang) GigaByte DPS blue LEDs
illuminate one at a time and then all go out at point of hang. I have
cleared CMOS and removed motherboard from chassis disconnecting all but VGA
card. This is a new system build and therefore has never booted. No O/S is
loaded on the machine. I have a 24 pin connector fitted to m/b, however I
only have a 2x2 12V supply to the CPU. All literature suggests that only on
a 840 and 845 CPU requires 2x4 12V..Is this correct... I have worked with
Gigabytes boards week in and week out and this seems an uncommon failure,
however it is the first Dual core system and so this hardware configuration
is unproven!
Has anyone run an 830D on this or any other board using just the 2x2 12v P4
supply?
Any help would be appreciated!