Narrowed Concave screen

[Guest]

I have a dell Dimension2350 2.8 ghz about 3 1/2 years old.
After a bit of flickering my screen suddenly reduced in width by about half.
ie. a quarter missing from either side which left a concave shaped(wider at
the top and bottom of the screen)with both left and right borders Black!
Everything else works as normal. Is it my graphics card?
If so, I have a Dimension3000(16 months old) at work in which i added a
matrox dual Graphics card a while back. So am I right in thinking that i
should be able to remove my original intel card fro the 3000 and put that
into the faulty 2350 with no ill effects to my 3000 mahcine?

 

[Galen]

In paul1961 had this to say:

My reply is at the bottom of your sent message:

I have a dell Dimension2350 2.8 ghz about 3 1/2 years old.
After a bit of flickering my screen suddenly reduced in width by
about half. ie. a quarter missing from either side which left a
concave shaped(wider at the top and bottom of the screen)with both
left and right borders Black! Everything else works as normal. Is it
my graphics card?
If so, I have a Dimension3000(16 months old) at work in which i added
a matrox dual Graphics card a while back. So am I right in thinking
that i should be able to remove my original intel card fro the 3000
and put that into the faulty 2350 with no ill effects to my 3000
mahcine?

It is very unlikely to be your card in this case. It is very likely the
monitor itself. Check the on-screen display buttons on the front of the
monitor first and if those don't help try another monitor and if your old
one is still covered under warranty then return it for a replacement.

--
Galen - MS MVP - Windows (Shell/User & IE)
http://dts-l.org/ http://kgiii.info/

"Chance has put in our way a most singular and whimsical problem, and
its solution is its own reward." - Sherlock Holmes

 

[Guest]

The buttons on the monitor only seem to be for brightness and contrast control.
I can substitute another monitor for this one on Monday and will do so.
The only question I have is when going into Monitor properties and graphics
card properties both are said to be working correctly. Is that par for the
course?

 

[Richard Urban]

The buttons on the monitor only seem to be for brightness and contrast
control.
I can substitute another monitor for this one on Monday and will do so.
The only question I have is when going into Monitor properties and
graphics
card properties both are said to be working correctly. Is that par for the
course?

You were told in another news group that what you see is only the condition
of the drivers/software. It has nothing to do with physically defective
hardware.

--

Regards,

Richard Urban
Microsoft MVP Windows Shell/User
(For email, remove the obvious from my address)

Quote from George Ankner:
If you knew as much as you think you know,
You would realize that you don't know what you thought you knew!

 

[Michael W. Ryder]

You were told in another news group that what you see is only the condition
of the drivers/software. It has nothing to do with physically defective
hardware.

I take it you have never seen a CRT die? Quite often when they start
failing the display shrinks until it gets too small to use. I have seen
them shrink down to a line a couple of pixels in width. As some of
those were being used as glass ttys there was no way any software or
drivers were involved.

 

[Galen]

In Richard Urban had this to say:

My reply is at the bottom of your sent message:

You were told in another news group that what you see is only the
condition of the drivers/software. It has nothing to do with
physically defective hardware.

That and keep poking at the front and you'll probably find other options to
adjust the screen size eventually. If not then, well, it's broken and
drivers and newsgroups won't get you squared away.

--
Galen - MS MVP - Windows (Shell/User & IE)
http://dts-l.org/ http://kgiii.info/

"Chance has put in our way a most singular and whimsical problem, and
its solution is its own reward." - Sherlock Holmes

 

[Richard Urban]

A CRT that has horizontal collapse is not, in any way, going to alter the
fact that the device manager will show everything as OK, both the monitor
and display adapter. All the device manager shows is the condition of the
drivers/software associated with the monitor and display adapter device. Not
the physical condition of the monitor.



--

Regards,

Richard Urban
Microsoft MVP Windows Shell/User
(For email, remove the obvious from my address)

Quote from George Ankner:
If you knew as much as you think you know,
You would realize that you don't know what you thought you knew!

 

[Michael W. Ryder]

A CRT that has horizontal collapse is not, in any way, going to alter the
fact that the device manager will show everything as OK, both the monitor
and display adapter. All the device manager shows is the condition of the
drivers/software associated with the monitor and display adapter device. Not
the physical condition of the monitor.

Maybe I misunderstood your post. The way it sounds is that the problem
was in the drivers/software, not the hardware.