MIRC's DCC, and Radmin are stuck at 0% when sending

[jameshanley39]

When I try to send files through Radmin or MIRC's DCC it is stuck at
0%. I am trying to send between 2 computers on a LAN connected through
a DLink router/modem. It does connect,. When I use Radmin I can see
the files on the other computer, so it's not a port redirection issue.
The DCC does accept the connection. Plus I dealt with the port
redirection thing anyway.

 

[Leythos]

The DCC does accept the connection. Plus I dealt with the port
redirection thing anyway.

Unless you have UPNP enabled on the router, DCC will not work, and it
may not work then either. DCC does not like NAT.

 

[q_q_anonymous]

UPNP is enabled

You're saying it's impossible?!!

 

[Leythos]

UPNP is enabled

You're saying it's impossible?!!

In my experience with Mirc and Pirch, when trying to DCC, it will
connect but not move any data. This is an issue with DCC and NAT, not
with NAT.

As for Radmin, I use Radmin 2.1 and have no problem with it, internal or
external. When using it across the internet to a system behind a NAT
device you have to port forward the default (or what port you tell it to
use) to the internal IP of the device running Radmin.