Mail Merge

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

When using Word mail merge and I select my access data base as the source for
data to merge, and then select a query to use for the merge it comes up
blank. All my querys show up but all of them return blank data to merge. Is
there a setting I am missing somewhere? Thank you.
 
Nathan--
I'm having the same trouble. Did you get this figured out? I used Access a
couple of years ago quite a bit, but not lately. I copied my table and
queries from an old disk, and changed a query. The records show up in the
query, but when I mail merge them into Word, no records appear.
Thanks.
Sheri
 
Have not figured it out yet.

Sheri said:
Nathan--
I'm having the same trouble. Did you get this figured out? I used Access a
couple of years ago quite a bit, but not lately. I copied my table and
queries from an old disk, and changed a query. The records show up in the
query, but when I mail merge them into Word, no records appear.
Thanks.
Sheri
Click to expand...
 
I found another user's question and went to a link it suggested, and did what
it said. I could finally get my records to show. It was from Microsoft's
Article ID 320476, Revision 1.2, Last review 1/7/06 (previously published
under Q320476). I don't use this community to know if that will help you or
not. If not, let me know and I'll re-type the steps it gave me. (Had to do
with confirming data source via DDE ~~ don't know what that means.) Sheri
 
Back
Top