hyperterminal not responding to keystrokes

  • Thread starter Thread starter John Smith
  • Start date Start date
J

John Smith

This is my first time using hyperterminal. In the "connect to"
windows, I entered the name of the remote computer and port
number. I was able to see the greeting message from the remote
computer. But the windows did not respond to the keyboard.
Whatever I typed did not show up in the windows and had no effect.

How exactly should I communicate with hyperterminal? How do I make
it recognize the keyboard input?
 
John Smith said:
This is my first time using hyperterminal. In the "connect to"
windows, I entered the name of the remote computer and port
number. I was able to see the greeting message from the remote
computer. But the windows did not respond to the keyboard.
Whatever I typed did not show up in the windows and had no effect.
Click to expand...

Try turning on local echo. Properties > Settings > ASCII setup.
You also might want to set "send line ends.."

Note that if the remote system echos back, you'll see ddoouubbllee
what you type.
 
Back
Top