R
rosenmarsh
Hello everybody
I have posted to this forum before regarding the above. At the moment I
am loading the CD tray pushing it a little so the rollers grab it, it
goes out the back and then comes in again. At this point what should
happen is that about halfway back through it should stop, printer heads
whirl into action and printing starts. Instead what is happening is
the CD comes all the way back out and I get message that CD/DVD tray is
not loaded correctly. I then reset the DVD tray press the middle
button which is flashing red and the whole process starts again. About
one in five times I get to print a CD. Is it time to throw the printer
out the window or is there anything I can do? (The clear plastic end
is still attached to the tray but as it is not bent as tray goes
through to the back fine, I assume it is not the problem.)
Thanks
Master
I have posted to this forum before regarding the above. At the moment I
am loading the CD tray pushing it a little so the rollers grab it, it
goes out the back and then comes in again. At this point what should
happen is that about halfway back through it should stop, printer heads
whirl into action and printing starts. Instead what is happening is
the CD comes all the way back out and I get message that CD/DVD tray is
not loaded correctly. I then reset the DVD tray press the middle
button which is flashing red and the whole process starts again. About
one in five times I get to print a CD. Is it time to throw the printer
out the window or is there anything I can do? (The clear plastic end
is still attached to the tray but as it is not bent as tray goes
through to the back fine, I assume it is not the problem.)
Thanks
Master