Enabling APM

[Andy Pont AMIAP]

Is it possible to enable the APM support from within TD rather than
having to do it from the APM tab of the "Power Options" control panel
applet?

Thanks in advance,

Andy.

 

[Rob]

If your box is ACPI Compliant you can set some of the
power options within the components themselves in Target
Designer. If it's not you have to go into the power
options in the Control Panel after you go through FBA.
You can however add the system cloning tool component to
your image and set the "CMI Reseal Phase" option in the
advanced settings to zero, build your image, run through
FBA, and when it finishes FBA it will boot to the desktop.
From that point you can make all of your settings changes
and 3rd party installs, manually reseal the drive
(Fbreseal in System32), and once the machine shuts down
after the reseal power off the machine. At this point you
can GHOST the drive and that will give you a pristine
image that you can use on any machine. All you will have
to do is configure the machine and user specific stuff
which you can script out. This is good if you have
hundreds of machines to image.

Robert