J
j_evilone
My 2 drive RAID setup went out and would freeze on reboot. I tried
GoBack and Recovery Console without any luck. I put a new hard drive
on an IDE channel, installed XP and was able to see the RAID array in
Disk Management and run diagnostics on it but I was unable to access
it. The array wouldn’t show up in My Computer or Windows Explorer.
When I right clickedt the array in Disk Management, the only option I
was given was to convert drive to Dynamic Disk. I did this (which I
probably shouldn’t have), but it only made the first partition (of 10)
of the array visible. The disk shows the 160 gb array as online, but
only shows 16 gb as available (the size of the first partition). Is
there any way to see the rest of the hard drive? I have 9 more
partions with information that I would like to retrieve. I would
appreciate any help. Thanks!
GoBack and Recovery Console without any luck. I put a new hard drive
on an IDE channel, installed XP and was able to see the RAID array in
Disk Management and run diagnostics on it but I was unable to access
it. The array wouldn’t show up in My Computer or Windows Explorer.
When I right clickedt the array in Disk Management, the only option I
was given was to convert drive to Dynamic Disk. I did this (which I
probably shouldn’t have), but it only made the first partition (of 10)
of the array visible. The disk shows the 160 gb array as online, but
only shows 16 gb as available (the size of the first partition). Is
there any way to see the rest of the hard drive? I have 9 more
partions with information that I would like to retrieve. I would
appreciate any help. Thanks!
iskPart Then type:list disk Then:list volume