Computer bulletin board

  • Thread starter Thread starter stryped
  • Start date Start date
S

stryped

x-no-archive:yes

We are a company that has an electronic bulletin board. There is a
computer with a monitor in each break room. Each is running Power
point. The receptionist has on her computer power point and controls
each computer int he breakroom through the network.

The problem is, if one of the breakroom computers locks up or the power
goes off she has to leave her desk and walk to each break room to
reboot the computer. (There are only two breakrooms).

One is probably 700 feet or so from the receptionist.

Is there a system where we could maybe give the receptionist a
dedicated computer or laptop and run wires to just a monitor directly
in each breakroom from her computer? Is there somethign else out there
not too expensive that would work.

I am not a total computer geek but understand the basics.

I appreciate any advice!
 
In the old days (showing my age), we used to hav a main switch panel that
all monitors were plugged in to this mainboard.

The output of the computer went to that board, and the output went to the
switch panel where all monitors were connected.

THis should be able to be done ... but I would probably post in one of the
hardware forums.
 
Back
Top