M
Moir
Trying to execute new firmware for a printer. The instructions say to make a
temporary folder (0255s)on my hard drive. Unzip the files into this folder.
Then later on, (after directions to do with ports) I am asked to "Go
to a DOS prompt and change to the "0255s" folder, type the following command
....pup(enter). The person who provides support does not have a very good
command of the English language and I am at a loss how to carry out these
instructions! How do I use the cmd prompt (WinXP Pro) to achieve what I am
supposed to do.
Thanks (from a non DOS user).
temporary folder (0255s)on my hard drive. Unzip the files into this folder.
Then later on, (after directions to do with ports) I am asked to "Go
to a DOS prompt and change to the "0255s" folder, type the following command
....pup(enter). The person who provides support does not have a very good
command of the English language and I am at a loss how to carry out these
instructions! How do I use the cmd prompt (WinXP Pro) to achieve what I am
supposed to do.
Thanks (from a non DOS user).