Cd printing on a R220

[Yachtboy1010]

The printer wont accept the cd tray. It kicks it out and says that the
tray is out of line. It is not . any ideas

 

[Fenrir Enterprises]

The printer wont accept the cd tray. It kicks it out and says that the
tray is out of line. It is not . any ideas

Push the tray in until you feel resistance. This will probably be
about 1/4" deeper than if you 'line up the arrows'. The printer will
correct the alignment once the tray is pulled in. Second, make sure
there's enough room in the /back/ of the printer. If the tray can't be
pulled through far enough, it will also kick it out.


---

http://www.FenrirOnline.com

Computer services, custom metal etching,
arts, crafts, and much more.

 

[Rob]

The printer wont accept the cd tray. It kicks it out and says that the
tray is out of line. It is not . any ideas

If its the same as the 200/210 then apply a little pressure and see if
it takes.

 

[measekite]

*SPAMMER*

Push the tray in until you feel resistance. This will probably be
about 1/4" deeper than if you 'line up the arrows'. The printer will
correct the alignment once the tray is pulled in. Second, make sure
there's enough room in the /back/ of the printer. If the tray can't be
pulled through far enough, it will also kick it out.


---

http://www.FenrirOnline.com

Computer services, custom metal etching,
arts, crafts, and much more.

 

[Woody]

Also check that the clear plastic tabs are on the back of the tray.