Can youn turn off/on the suspend/hibernate option when shutting down

[Guest]

Hi,

For the last 3 months things have been running fine until last week chkdsk found errors after a boot failed.
Now most things are fine however when I click on shutdown the suspend/hibernate option is greyed out. It used to be available. Also now I can't select a resolution higher than 1024 x 768 32 bit while previously it was 1280 x 1024 32 bit.

Any suggestions on either of these 2 problems are appreciated

 

[Guest]

----- Stevo wrote: ----

Hi

For the last 3 months things have been running fine until last week chkdsk found errors after a boot failed
Now most things are fine however when I click on shutdown the suspend/hibernate option is greyed out. It used to be available. Also now I can't select a resolution higher than 1024 x 768 32 bit while previously it was 1280 x 1024 32 bit

Any suggestions on either of these 2 problems are appreciate

I have the same Standby/ hibernate problem. I also have a "Found new hardware (unknown)" notice when there is nothing plugged in my USB ports on start-up.