- Joined
- Jun 22, 2005
- Messages
- 19
- Reaction score
- 0
Hi,
I tried to start my embedded image in "Save Mode" (pressing F8 upon startup), but Windows XPE always crashed with a Blue Screen Stop Error: "Stop 0x0000007B (0xF7C1E528, 0xC0000034, 0x00000000, 0x00000000)".
I suspect there's one or more component missiong required to run XPE in "Save Mode" but don't know which ones. The Target Designer help does not say anything about "Save mode" or necessary components.
As far as I know 0x0000007B is [size=-1]INACCESSIBLE_BOOT_DEVICE and normally occurs when critical hardware is changed or drivers are missing. Seems as if "Save mode" requires device drivers that are not used in "normal" mode, or conflict with the EWF or EWF disk mode I run the image in.[/size]
Any ideas?
Thx.
skagway095
I tried to start my embedded image in "Save Mode" (pressing F8 upon startup), but Windows XPE always crashed with a Blue Screen Stop Error: "Stop 0x0000007B (0xF7C1E528, 0xC0000034, 0x00000000, 0x00000000)".
I suspect there's one or more component missiong required to run XPE in "Save Mode" but don't know which ones. The Target Designer help does not say anything about "Save mode" or necessary components.
As far as I know 0x0000007B is [size=-1]INACCESSIBLE_BOOT_DEVICE and normally occurs when critical hardware is changed or drivers are missing. Seems as if "Save mode" requires device drivers that are not used in "normal" mode, or conflict with the EWF or EWF disk mode I run the image in.[/size]
Any ideas?
Thx.
skagway095
Last edited: