Another (possibly new) Stop 7b question

[Santiago Allen]

Hi guys,

I normally dont come to the forums for one of these, but this stop 7b
has me stumped. Heres whats happening.

I have a perfectly good slx file for my target using Enhanced Write
Filter and including the Ewf enabling components : (Enhanced Write
Filter, EWF Ntldr, EWF COnsole App, Disk Defrag Disabled).

I remove all of those components and replace them with the standard NT
Loader.

A dependency check shows nothing is missing.

The image goes to stop 7b during FBA.

What i dont understand is why the image would stop working after
removing the EWF. ANy ideas?

 

[Sean Liming \(MVP\)]

Did you wipe the target disk clean so the EWF volume partition was removed?
Did any of the chipset or disk drive components somehow get removed?


--
Regards,

Sean Liming
www.sjjmicro.com / www.seanliming.com
Book Author - XP Embedded Advanced, XP Embedded Supplemental Toolkit

 

[Santiago Allen]

Hi Sean,

That one may be it, do I need to re-create the entire partition with
diskpart?

I tend to use an sdi disk loaded through sdiloader and then install
the contents via sdimgr, im working with a Disk On Module.

I suppose I should make a non-ewf sdi and try that?

 

[Sean Liming \(MVP\)]

I try to avoide SDI transfer. I use XPE booting from USB or Winternal's
Remote Recover.

Try without EWF, and see what happens.

Regards,

Sean Liming
www.sjjmicro.com / www.seanliming.com
Book Author - XP Embedded Advanced, XP Embedded Supplemental Toolkit