adding a gigabit driver to RIS image

G

Guest

I have been successful in adding my 3rd party 10/100 net driver (Intel
82559ER) to my RIS image. It loads fine.
I try the same procedure for my gigabit adapter (also an Intel part) it
fails and says it is the wrong driver. I believe the driver is right as I
can load it on a cd installed image and the gigabit works. After adding the
gig driver in the cd installed image it reports it is signed.
I notice when I copy the gig driver to my image it replaces an existing
1000NT5.sys. This doesn't happen on the 10/100 scenario. The driver there is
unsigned.
Any suggestions?
thanks!
SG
 

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Similar Threads

Dell Optiplex graphics driver failure 2
How to add network driver to ris image for compaq evo 1
RIS: Adding drivers to image ? 1
RIS Problem installing 3rd Party Unsigned Driver for Boot Device 8
No image created on RIS server 1
RIS NIC driver error 1
RIS installation and Marvell Yukon Ethernetcontroller 2
RIS 2003 PnP drivers 2

Top