Display settings must be reset after bootup.

[JimB]

I have an ATI AIW9800. Just upgraded to an LCD monitor and am driving it
through the DVI connector. At first I was very disappointed with the
appearnce of the display contacted the manufacture and they said to check
the Video Card settings. This turned out to be my problem. I went to the
ATI control panel which can be accessed via the Propertied, Settings,
Advanced then go to the Color tab. I just needed to adjust the Brightness,
Contrast and Gamma via the video card.
Only problem is that I must revisit this setup after the computer boots up.
I merely have to open the tab and the settings take hold.

Question: Is there someway to make these settings automatically function at
bootup without having to perform this manual setup?

JimB

 

[peterk]

On both of my LCD monitors I am able to adjust the color on the
monitor.....Can you on yours??.....would this solve your problem??
peterk