I
Irv Rollman
I have a WD 200GB HDD I installed into my system. It is
using the controller shipped with the drive (a half-card
Promise), which has a BIOS supporting 200GB. During boot,
the controller detects the drive at 200GB. (Well, 186 GB
actually, once you do the 1024 to 1000 conversion!)
I have WinXP with SP1 installed on my system. Also
installed is the newest atapi.sys from MS KB823980
article. In Control Panel/ Admin Tools/ Computer
Mangement/ Storage, it only shows the disk as 128GB. Why?
How can I correct?
Thanks in advance,
Irv Rollman, Denver
using the controller shipped with the drive (a half-card
Promise), which has a BIOS supporting 200GB. During boot,
the controller detects the drive at 200GB. (Well, 186 GB
actually, once you do the 1024 to 1000 conversion!)
I have WinXP with SP1 installed on my system. Also
installed is the newest atapi.sys from MS KB823980
article. In Control Panel/ Admin Tools/ Computer
Mangement/ Storage, it only shows the disk as 128GB. Why?
How can I correct?
Thanks in advance,
Irv Rollman, Denver