J
Jim H
I have used PowerQuest DriveImage 5.0 to make a copy of c:
on a second physical drive, and then used Partition Magic
6.0 to change my 80GB c: to 10GB. As PM would not resize
the partition, I had to delete and start from scratch.
Everything went ok mostly, and all is well now, except
that I cannot access the Drive Image files. I have 2
images - one in 640mb chunks and the other in one 2.1GB
file. All partitions involved are NTFS.
When I try to access the files with Drive Image Explorer I
get error 1810 - the image could not be accessed. If I
try to copy the files with Windows Explorer I get "cannot
copy ivc_2: access is denied. Make sure the disk is not
full or write protected, and the file is not currently in
use." The destination has 5GB to spare, and I can copy
other files to it. I get the same result in safe-mode.
One last point - I used a Windows ME boot floppy to run
Drive Image 5.0. I suspect there may be a FAT32/NTFS
problem here???
Thanks
on a second physical drive, and then used Partition Magic
6.0 to change my 80GB c: to 10GB. As PM would not resize
the partition, I had to delete and start from scratch.
Everything went ok mostly, and all is well now, except
that I cannot access the Drive Image files. I have 2
images - one in 640mb chunks and the other in one 2.1GB
file. All partitions involved are NTFS.
When I try to access the files with Drive Image Explorer I
get error 1810 - the image could not be accessed. If I
try to copy the files with Windows Explorer I get "cannot
copy ivc_2: access is denied. Make sure the disk is not
full or write protected, and the file is not currently in
use." The destination has 5GB to spare, and I can copy
other files to it. I get the same result in safe-mode.
One last point - I used a Windows ME boot floppy to run
Drive Image 5.0. I suspect there may be a FAT32/NTFS
problem here???
Thanks