Assuming you have the software installed and you don't have the icon in the system tray, you should be able to run the HP software from all programs.
Bob Lin, MS-MVP, MCSE & CNE
Networking, Internet, Routing, VPN Troubleshooting on
http://www.ChicagoTech.net
How to Setup Windows, Network, VPN & Remote Access on
http://www.HowToNetworking.com
Hi:
Thanks for the responses.
I could not 'add printer,' even though I used 'Add Hardware Wizard,' then there is NO 'HP 3300 All-in
One' icon in the system tray. The computer could NOT find the 'All-in-One,' although it says,
everything working fine when I went to 'Device Manager' to look at Printer which is on the Device
Manager.
Besides this, the second computer could not load 'scan' that is one of 'All-in-One' features, although
I managed to install in full on the first computer. There is no 'All-in-One' icon in the system tray
at the lower right side of the screen, either.
However, there is 'All-in-One,' on Printer & Fax from Control Panel.
Is this to be a problem NOT able to 'share printer?'
Thanks,
Have you installed the software? The HP All-in-One software must be installed and running on the computer.. To verify that the HP All-in-One software is running on a Windows system, look for the HP All-in-One icon in the system tray at the lower right side of the screen.
Bob Lin, MS-MVP, MCSE & CNE
Networking, Internet, Routing, VPN Troubleshooting on
http://www.ChicagoTech.net
How to Setup Windows, Network, VPN & Remote Access on
http://www.HowToNetworking.com
Hi:
My printer, 'HP Photosmart 3300 All-in-One series' has already
'wireless' feature installed. Then, I thought it was NOT hard for me
to make 'Printer Sharing.'
However, for some reason, I have not completed 'Printer Sharing,' even
though I did this by 'Network Wizard' on both computers.
My computers, HP have same features with Windows XPs.
Is there any way to make 'Printer Sharing?'
Thanks for your help in advance.