system not booting

  • Thread starter Thread starter Vani
  • Start date Start date
V

Vani

Hello,
I did a clean install of Winxp professional on
Dell PC (celeron processor 660MHZ) with 128MB RAM and
38Gb Hard disk. The installation went fine. But after the
system boots, it says "windows has encountered error and
is shutting down". When I reboot it just hangs at the
logo with a blur screen with error message "KERNEL-DATA-
INPAGE-ERROR WIN32.SYS
Can someone help me with the steps to solve this problem?

Thanks,
Vani
 
Courtesy of http://aumha.org/win5/kbestop.htm Check your hard drive
with a diagnostic utility from the manufacturers site.
0x0000007A: KERNEL_DATA_INPAGE_ERROR
(Click to consult the online Win XP Resource Kit article, or see Windows
2000 Professional Resource Kit, p. 1553.)
A page of kernel data was not found in the pagefile and could not be read
into memory. This might be due to incompatible disk or controller drivers,
firmware, or hardware
 

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Back
Top