System has recovered from a serious error

[Bernie]

I keep on getting this message when I boot my computer:

TI BlackLink Service/TI Graph Link (ticalc.sys) is not compatible with your
version of Windows

Thank you for submitting an error report.

Problem Description

The error was likely caused by: TI BlackLink Service/TI Graph Link
(ticalc.sys). TI BlackLink Service/TI Graph Link (ticalc.sys) is not
compatible with the version of Microsoft Windows that you are using.

Problem Resolution

TI BlackLink Service/TI Graph Link (ticalc.sys) was created by Texas
Instruments. You should contact Texas Instruments in order to find out if a
solution or an updated version of TI BlackLink Service/TI Graph Link
(ticalc.sys) is available. For more information, see the Texas Instruments
Web site.

http://education.ti.com/support

If you are unable to locate an update, Microsoft recommends that you remove
TI BlackLink Service/TI Graph Link (ticalc.sys) to prevent the error from
occurring again. Click here for instructions.

The problem is I no longer have TI Black Link. I deleted it sometime ago.
What should I do?

 

[Larry(LJL269)]

On Wed, 6 Apr 2005 06:23:43 -0500, "Bernie"

|The problem is I no longer have TI Black Link. I deleted it sometime ago.
|What should I do?
Run MSconfig > Startup & disable any entries to it.

HTH-Larry
Any advise is my attempt to contribute more than I have received but I can only assure you that it works on my PC. GOOD LUCK.

 

[Bob I]

Ahh, perhaps doing as the instructions suggest.

 

[JEEPERS]

I have same problem. I went to C/WINDOWS/SYSTEM32/DRIVERS/Ticalc
and copied it to another location outside DRIVERS and DELETED IT FROM
DRIVERS. Try that.

 

[Kelly]

Use one of these three options.

Right Click the My Computer Icon/Properties/Advanced/
Performance/Settings/Advanced/Change.

1. Set Page File to 0, ok your way out and reboot. Then follow the same
procedure and reset the Page File to System Managed File.

2. No Page File. Reboot. Then delete C:\Pagefile.Sys then revert the page
file setting.

3. Set the swap file size to zero, reboot. Re-set to System Managed,
reboot. Reset the Custom setting, reboot.

You Receive a "System Has Recovered from a Serious Error" Message After
Every Restart
http://support.microsoft.com/default.aspx?scid=kb;EN-US;q317277

Windows XP Problems if Your Profile Is Damaged
http://support.microsoft.com/default.aspx?scid=kb;EN-US;Q326688


--

All the Best,
Kelly (MS-MVP/DTS&XP)

Taskbar Repair Tool
http://www.kellys-korner-xp.com/taskbarplus!.htm