sp1 problem

  • Thread starter Thread starter polzark
  • Start date Start date
P

polzark

i have recently installed sp1 on my computer and after the
installation completed and i made restart my system
doesn't log on and when the 'windows xp
professional'screen comes up the system makes restart and
i can only log ni safe mode
 
SP1 automatically creates a restore point before continuing with SP1
installation. Boot into Safe Mode and choose that restore point.

regards, Richard
 
polzark said:
i have recently installed sp1 on my computer and after the
installation completed and i made restart my system
doesn't log on and when the 'windows xp
professional'screen comes up the system makes restart and
i can only log ni safe mode

Boot into Safe Mode.

Then open Control Panel - System - Advanced and click on the Settings
button in the Startup and Recovery (bottom) section.

In the Startup and Recovery window click on the checkbox for
"automatically restart" to clear it.

Click on Apply and OK as needed to exit.

Shut down and restart the computer.

That should put an end to the restarts. However they may be replaced
by a "Blue Screen Of Death" STOP error message. If so then the
contents of the STOP message will be a direct clue as to the
underlying cause of the problem. Post the complete text of the STOP
error message, including all of the parameter codes, back here if you
need further assistance with resolving this.

Good luck


Ron Martell Duncan B.C. Canada
--
Microsoft MVP
On-Line Help Computer Service
http://onlinehelp.bc.ca

"The reason computer chips are so small is computers don't eat much."
 

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Back
Top