G
Guest
Since I removed my slave HDD it take 28 minutes to boot. There no error
messages and after boot it runs normally. So far took these actions:
1. set jumper to CS and master
2 reinstalled an additional drive trying both master-slave jumpers and CS:
there is no change.
Initially master was the current 300GB and slave 200 GB. In the above test I
replace the slave with an old 4GB.
What else can I do to remedy this problem?
messages and after boot it runs normally. So far took these actions:
1. set jumper to CS and master
2 reinstalled an additional drive trying both master-slave jumpers and CS:
there is no change.
Initially master was the current 300GB and slave 200 GB. In the above test I
replace the slave with an old 4GB.
What else can I do to remedy this problem?