SATA RAID NCCH-DL???

  • Thread starter Thread starter ~KC~
  • Start date Start date
K

~KC~

Hello,
I just purchased the ASUS NCCH-DL dual Xeon motherboard
I would like to set up 2 identical 160 GB SATA drives as RAID 1 (Mirrored).
What mother board sata plugins do I use?
There are 4 labeled SATA RAID and 2 labeled SATA.
Do I use SATA_RAID1 and SATA_RAID2 or SATA1 and SATA_RAID1?

Thanks for your help.
Ken
 
I just purchased the ASUS NCCH-DL dual Xeon motherboard
I would like to set up 2 identical 160 GB SATA drives as RAID 1
(Mirrored).
What mother board sata plugins do I use?
There are 4 labeled SATA RAID and 2 labeled SATA.
Do I use SATA_RAID1 and SATA_RAID2 or SATA1 and SATA_RAID1?
Click to expand...

Just plug them into any two of the four SATA_RAID connectors.
You will then need to enter the SATA RAID controller's setup
(it's message should appear on the screen during bootup) in
order to configure the array.
 
Thank you!


KC Computers said:
Just plug them into any two of the four SATA_RAID connectors.
You will then need to enter the SATA RAID controller's setup
(it's message should appear on the screen during bootup) in
order to configure the array.
Click to expand...
 

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Similar Threads

New Raid Confusion P4P800-E 1
P4P800-E Deluxe: S-ATA and RAID 1
MB Monitor for NCCH-DL? 1
asus ncch-dl enermax eps 12v/atx GES Hibernate problem? 1
P4C800-E Deluxe -- Booting from SATA when PATA drive is installed 4
Question about RAID (P4C800) 3
P4C800-E Deluxe change 1 SATA --> 2 new SATA in RAID 1 5
Problem w/ SATA HD on ASUS K8V SE Deluxe MB 4

Back
Top