RIS Setup Issue

[Ram]

Hai,

I am not sure this the correct forum to ask about RIS Question.I hope that
someone will help me out.

I have installed RIS in one of my server which is member of domain.Now i am
facing the issue the client systems are not getting ip from my DHCP (client
systems are having PXE on LAN)When i boot from PXE, the systems shows

DHCP..........

Then it says as No file found When i run the risetup -check it does not show
any error message but it getting authozied by Domain Server.
Moreover I just gone through the DHCP console and verified that RIS has been
Authorized by domain.

Even i have hecked in the event log, it shows

"The Remote Installation service has been authorized to run on this server
by the DHCP service."

Event ID:1045

When i restart the RIS Service i am getting the error in event log which is
mentioned in below

Event ID: 1001

" The DHCP service failed to register with Service Controller. The
following error occurred:
The operation completed successfully. .

For more information, see Help and Support Center at
http://go.microsoft.com/fwlink/events.asp."

Please help me to reslove this issue....

Thanks in advance....
Raam

 

[Guest]

Be sure the client is on the same switch segment as the RIS server.