Reset RRAS to Default Configuration

B

Ben

Hi

I have got our RRAS into a pickle, I have had countless problems configuring
our VPN.

Whilst attempting to solve the problem causing clients to receive the error
below when attempting a PPTP connection:

VPN Tunnel Type RADIUS attribute for this user is not correct. (Error 795)

Now the server is not responding to any connections - is there any way to
reset the RRAS to its default configuration?

Thanks Ben
 
P

Priya Raghavan [MSFT]

Do you have a Remote Access Policy on your RAS or IAS Server which has
"Tunnel Type" attribute ?
Can you check the value for that attribute ?
 
D

Dusty Harper {MS}

If you Disable RRAS and then Configure and Enable it, you will be back in
the default state. before doing so, you may want to use netsh and take a
snapshot of your current configuration ( it may save you a bit of work )
Netsh Routing dump > Config.txt
 

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Similar Threads

win2003, rras & nat enable, ftp server 1
RRAS configuration questions 1
VPN Tunnel Type RADIUS attribute for this user is not correct. (Error 795) 2
RRAS (for VPN) and IIS on the same server? 3
SBS 2003 RRAS ERROR... 0
RRAS default route 3
RRAS as VPN Server Configuration Questions... New one... 3
Win2K RRAS/VPN Help 5

Top